Re-Flect RC

Interior Radiation Control Coating System


Product Description  
                                                                                                                                
RE-FLECT RC is an aluminum colored, water-based, low emmisivity 
(low-e) coating. When applied to building materials such as plywood, OSB, 
plasterboard, metal, and concrete RE-FLECT RC lowers their surface emissivity, thereby blocking over 75% of the radiant heat trying to enter the 
home. It is classified by ASTM as an Interior Radiation Control Coating (IRCC).

Basic Use  
                                                                                                                                                     
RE-FLECT RC is designed to be applied to the underside of the attic deck of the underside of a roof to significantly reduce the amount of radiant heat 
entering the structure, thereby reducing cooling requirements. 

Limitations    
                                                                                                                                                
RE-FLECT RC is designed for interior use only. Surface must be dry. Apply at temperatures between 40 degrees F and 120 degrees F. Do not tint, add water or any other liquid or coat over the top! There must be air space on one side of RE-FLECT RC to be effective. We recommend 2 inches of air space. 

Preparation   
                                                                                                                                       
Provide mechanical ventilation from a) home interior-to-attic-to-outside and b) outside-to-atticto-outside. Run ventilation 10 minutes prior to use, during use, and for at least 30 minutes after application. Mix thoroughly for 2 to 3 minutes, handstirring with a wooden paddle. All surfaces must be clean and dry.

Application 
                                                                                                                                                 
RE-FLECT RC may be applied by brush, roller, or sprayer. The preferred method is spraying. If using an airless sprayer, recommended pressure is 1,500 -2,000 psi using tip size of 0.013” – 0.015”. For best results, use a spray pump size 3/4 GPM or greater. A 3/8” synthetic-nap roller can also be used.

Coverage
                                                                                                                                                    
One gallon will cover 400-500 sq. ft. of surface depending on the porosity of the surface.

Packaging    
                                                                                                                                                    
1 gallon or 5 gallon containers, ready to use.
                        
Technical Service  
                                                                                                                               
Technical advice on use of material for specific 
application and end use requirements are available 


Warranty       
                                                                                                                                               
This product is manufactured of good materials and by competent workmen. Seller’s and manufacturer’s only obligations shall be to replace such quantity of product proved to be defective. Neither seller nor manufacturer shall be liable for any injury, loss or damage, direct or consequential, arising from the 
use or the inability to use the product. Before installing, user shall determine the suitability of the product for his/her intended use; and user assumes 
all risk and liability